SYSTem:COMMunicate:LAN:CURRent:SMASk?
This command returns the current setting of the LAN subnet mask in use by the
power meter.
If DHCP or AutoIP are successfully enabled, then one of these IP address modes
NOTE
assign the LAN subnet mask, otherwise it is the static LAN subnet mask.
Syntax
SYST
Example
SYST:COMM:LAN:CURR:SMAS?
N1911A/1912A P-Series Power Meters Programming Guide
:COMM
:LAN
:CURR
:SMAS
This command queries the current setting of
the LAN subnet mask.
SYSTem Subsystem
?
12
501