Using Status - Keysight N1911A Programming Manual

P-series power meters

Hide thumbs Also See for N1911A:

Table of Contents

Power Meter Remote Operation

If TRIGger:DELay:AUTO is set to ON, then the number of failures returned by

SENSe:LIMit:FCOunt? or CALCulate[1|2]:LIMit:FCOunt? is affected by the

current filter settings.

Using STATus

If using GPIB, you can use the STATus subsystem to generate an SRQ to interrupt

your program when a limit failure occurs. This is a more efficient method than

using SENSe or CALCulate, since you do not need to check the limit failures after

every power measurement.

further information.

"Status Reporting"

on page 73 and

N1911A/1912A P-Series Power Meters Programming Guide

"STATus Subsystem"

on page 465 for

Table of Contents