Redistribute - Dell S6000 Reference Manual

•
On configuring suppression using the passive-interface command, the state of the
OSPF neighbor does not change to INIT; instead, the state of the OSPF neighbor
changes to DOWN after the dead-timer expires.

redistribute

Redistribute information from another routing protocol throughout the OSPF process.
S6000
Syntax
redistribute {connected | isis | ospf | rip | static} [metric
metric-value | metric-type type-value] [route-map map-name]
[tag tag-value]
To disable redistribution, use the no redistribute {connected | isis |
rip | static} command.
Parameters
connected
isis
ospf
rip
static
metric metric-
value
metric-type
type-value
route-map
map-name
tag tag-value
Defaults Not configured.
Command ROUTER OSPF
Modes
Open Shortest Path First (OSPFv2 and OSPFv3)
May update ABR status.
Enter the keyword connected to specify that information
from active routes on interfaces is redistributed.
Enter the keyword isis to specify that ISO IS-IS information is
redistributed.
Enter the keyword ospf to specify that information
corresponding to OSPF is redistributes.
Enter the keyword rip to specify that RIP routing
information is redistributed.
Enter the keyword static to specify that information from
static routes is redistributed.
(OPTIONAL) Enter the keyword metric then a number. The
range is from 0 (zero) to 16777214.
(OPTIONAL) Enter the keywords metric-type then one of
the following:
• 1 = OSPF External type 1
• 2 = OSPF External type 2
(OPTIONAL) Enter the keywords route-map then the name
of the route map.
(OPTIONAL) Enter the keyword tag then a number. The
range is from 0 to 4294967295.
1001