Dell S6000 Reference Manual page 734

To delete all routes matching a certain route, use the no ip route
destination mask command.
Parameters
vrf vrf-name
destination
mask
ip-address
interface ip-
address
distance
permanent
tag tag-value
vrf vrf-name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version 9.2.
(0.0)
734
(Optoinal) Enter the keyword vrf and then the name of the
VRF to configure a static route corresponding to that VRF.
Use this VRF option after the ip route keyword to
configure a static route on that particular VRF.
Enter the IP address in dotted decimal format of the
destination device.
Enter the mask in the slash prefix format (/x) of the
destination IP address.
Enter the IP address of the forwarding router in dotted
decimal format.
Enter the keyword interface then the IP address.
(OPTIONAL) Enter the value of the distance metric assigned
to the route. The range is from 1 to 255.
(OPTIONAL) Enter the keyword permanent to specify that
the route must not be removed even if the interface assigned
to that route goes down. The route must be currently active
to be installed in the routing table. If you disable the
interface, the route is removed from the routing table.
(OPTIONAL) Enter the keyword tag then a number to assign
to the route. The range is from 1 to 4294967295.
Enter the keyword vrf followed by the name of the VRF. Use
this VRF option after the next hop to specify which VRF the
next hop belongs to. This setting is used in route leaking
cases. Refer to Route Leaking.
Added support for VRF.
Introduced on the S6000.
Added support for tunnel interface type.
IPv4 Routing