Router Ospf - Dell S6000 Reference Manual

n]:
Dell#

router ospf

To configure an OSPF instance, enter ROUTER OSPF mode.
S6000
Syntax
router ospf process-id [vrf {vrf name}]
To clear an OSPF instance, use the no router ospf process-id command.
Parameters
process-id
vrf name
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.1(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.9.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage You must have an IP address assigned to an interface to enter ROUTER OSPF mode
Information and configure OSPF.
After the OSPF process and the VRF are tied together, you cannot use the OSPF
Process ID again in the system.
1006
Enter a number for the OSPF instance. The range is from 1 to
65535.
(Optional) Enter the VRF process identifier to tie the OSPF
instance to the VRF. All network commands under this OSPF
instance are then tied to the VRF instance.
Introduced on the S6000.
Added support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRF.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)