Description - Dell S6000 Reference Manual

description

Enter a description of the spanning tree.
S6000
Syntax
description {description}
To remove the description from the spanning tree, use the no description
{description} command.
Parameters
description
Defaults none
Command SPANNING TREE (The prompt is "config-stp".)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
pre-Version
7.7.1.0
Related protocol spanning-tree
Commands
disable
Disable the spanning tree protocol globally on the switch.
S6000
Syntax
disable
To enable Spanning Tree Protocol, use the no disable command.
Defaults Enabled (that is, the spanning tree protocol is disabled.)
1398
Enter a description to identify the spanning tree (80
characters maximum).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
— enters SPANNING TREE mode on the switch.
Spanning Tree Protocol (STP)