Ntp Authenticate - Dell S6000 Reference Manual

Version 7.5.1.0
pre-Version
6.1.1.0

ntp authenticate

Enable authentication of NTP traffic between the switch and the NTP time serving hosts.
S6000
Syntax
ntp authenticate
To disable NTP authentication, use the no ntp authentication command.
Defaults Not enabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage You also must configure an authentication key for NTP traffic using the ntp
Information
authentication-key command.
1418
Introduced on the C-Series.
Introduced on the E-Series.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
System Time and Date