Untagged - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

Version 9.0.2.0

Version 8.3.11.1

Version 8.5.1.0

Version 8.3.7.0

Version 7.6.1.0

Version 7.5.1.0

When this command is configured, the VLAN is operationally UP if any of the

interfaces specified in the track ip command are operationally UP, and the VLAN

is operationally DOWN if none of the tracking interfaces are operationally UP.

If the track ip command is not configured, the VLAN's Layer 3 operational state

depends on all the members of the VLAN.

The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the

track ip command configuration.

interface vlan

untagged

Add a Layer 2 interface to a VLAN as an untagged interface.

untagged interface

To remove an untagged interface from a VLAN, use the no untagged interface

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— configures a VLAN.

— specifies which interfaces in a VLAN are tagged.

Enter the following keywords and slot/port or number

information:

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.