Dell S6000 Reference Manual page 1098

vlan vlan-range
cost number
priority value
loopguard
rootguard
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.4.2.1
Version 8.3.7.0
1098
Enter the keyword vlan then the VLAN numbers. The range
is from 1 to 4094.
Enter the keyword cost then the port cost value. The range
is from 1 to 200000.
Defaults:
• 100 Mb/s Ethernet interface = 200000.
• 1-Gigabit Ethernet interface = 20000.
• 10-Gigabit Ethernet interface = 2000.
• Port Channel interface with one 100 Mb/s Ethernet =
200000.
• Port Channel interface with one 1 Gigabit Ethernet =
20000.
• Port Channel interface with one 10 Gigabit Ethernet =
2000.
• Port Channel with two 1 Gigabit Ethernet = 18000.
• Port Channel with two 10 Gigabit Ethernet = 1800.
• Port Channel with two 100 Mbps Ethernet = 180000.
Enter the keyword priority then the Port priority value in
increments of 16. The range is from 0 to 240. The default is
128.
(C-, S-, and E-Series TeraScale only) Enter the keyword
loopguard to enable loop guard on a PVST+ port or port-
channel interface.
(C-, S-, and E-Series TeraScale only) Enter the keyword
rootguard to enable root guard on a PVST+ port or port-
channel interface.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced the loopguard and rootguard options on the
E-Series TeraScale, C-Series, and S-Series.
Introduced on the S4810.
Per-VLAN Spanning Tree Plus (PVST+)