Dell S6000 Reference Manual page 1300

vrf instance
ipv4 address
ipv6-address
prefix-length
-c encryption
cipher
-l username
-m HMAC
algorithm
-p port-
number
-v {1 | 2}
Defaults As shown in the Parameters section.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
1300
(OPTIONAL) E-Series Only: Enter the keyword vrf then the
VRF Instance name to open an SSH connection to that
instance.
(OPTIONAL) Enter the IP address in dotted decimal format
A.B.C.D.
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the following encryption cipher. (For v2 clients only.):
• 3des-cbc: Force ssh to use 3des-cbc encryption cipher.
(OPTIONAL) Enter the keyword -l then the user name used
in this SSH session. The default is the user name of the user
associated with the terminal.
Enter one of the following HMAC algorithms to use. (For v2
clients only.):
• hmac-sha1: Force ssh to use the hmac-sha1 HMAC
algorithm.
• hmac-sha1-96: Force ssh to use the hmac-sha1-96
HMAC algorithm.
• hmac-md5: Force ssh to use the hmac-md5 HMAC
algorithm.
• hmac-md5-96: Force ssh to use the hmac-md5-96
HMAC algorithm.
(OPTIONAL) Enter the keyword -p then the port number.
The range is from 1 to 65536. The default is 22.
(OPTIONAL) Enter the keyword -v then the SSH version 1 or
2. The default is the version from the protocol negotiation.
Added support for VRF.
Introduced on the S6000.
Security