Ip Msdp Mesh-Group - Dell S6000 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 6.2.1.1

ip msdp mesh-group

To be a member of a mesh group, configure a peer.
S6000
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group
{name} {peer address} command.
Parameters
name
peer address
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 6.2.1.1
Usage An MSDP mesh group is a mechanism for reducing SA flooding, typically in an
Information intra-domain setting. When some subset of a domain's MSDP speakers are fully
meshed, they can be configured into a mesh-group. If member X of a mesh-group
receives a SA message from an MSDP peer that is also a member of the mesh-
group, member X accepts the SA message and forwards it to all of its peers that are
Multicast Source Discovery Protocol (MSDP)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter a string of up to 16 characters long for as the mesh
group name.
Enter the peer address in a dotted decimal format (A.B.C.D.).
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
929