Basic Interface Commands - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

The commands in this chapter are supported by Dell Networking operating software on the S6000

This chapter contains the following sections:

Basic Interface Commands

Port Channel Commands

This chapter contains the following sections:

Basic Interface Commands

Port Channel Commands

Time Domain Reflectometer (TDR)

UDP Broadcast

Basic Interface Commands

The following commands are for Physical, Loopback, and Null interfaces.

clear counters

Clear the counters used in the show interfaces commands for all virtual router redundancy protocol

(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.

clear counters [interface] [vrrp [ipv6 {vrid} | learning-limit]

(OPTIONAL) Enter any of the following keywords and slot/

port or number to clear counters from a specified interface:

For IPv4 access-group counters, enter the keyword ip.

For IPv6 access-group counters, enter the keyword ipv6.

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For MAC access-group counters, enter the keyword mac.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For the management interface on the RPM, enter the

keyword ManagementEthernet then slot/port

information. The slot range is from 0 to 1 and the port