Dell S6000 Reference Manual page 803

To return to the default values, use the no distribute-list prefix-list-
name out [bgp as number connected | ospf process-id | rip |
static] command.
Parameters
prefix-list-
name
connected
ospf process-id
bgp as number
rip
static
Defaults Not configured.
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version 7.5.1.0
Version 6.3.1.0
Usage You can assign a name to a routing process so a prefix list IS applied to only the
Information routes derived from the specified routing process.
Related
•
Commands
•
Intermediate System to Intermediate System (IS-IS)
Specify the prefix list to filter prefixes in routing updates.
(OPTIONAL) Enter the keyword connected for directly
connected routing process.
(OPTIONAL) Enter the keyword ospf then the OSPF
process-ID number. The range is from 1 to 65535.
(OPTIONAL) Enter the BGP then the AS Number. The range is
from 1 to 65535.
(OPTIONAL) Enter the keyword rip for RIP routes.
(OPTIONAL) Enter the keyword static for user-configured
routing process.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Added IPv6 ISIS support.
Introduced.
distribute-list in — filters the networks received in updates.
redistribute — redistributes routes from one routing domain to another routing
domain.
803