Tacacs-Server Host - Dell S6000 Reference Manual

tacacs-server host

Specify a TACACS+ host.
S6000
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address}
[port number] [timeout seconds] [key key]
Parameters
hostname
ipv4-address |
ipv6-address
port number
timeout
seconds
key key
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.4.1.0
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
Security
Enter the name of the TACACS+ server host.
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of the TACACS+ server host.
(OPTIONAL) Enter the keyword port then a number as the
port to be used by the TACACS+ server. The range is from
zero (0) to 65535. The default is 49.
(OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+
server. The range is from 0 to 1000. The default is 10
seconds.
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This
authentication key must match the key specified in the
tacacs-server key for the TACACS+ daemon.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for IPv6.
Introduced on the S4810.
Authentication key length increased to 42 characters.
Introduced on the S-Series.
Introduced on the C-Series.
1263