Ip Tcp Initial-Time - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Version 8.1.1.0

Version 7.6.1.0

Version 7.5.1.0

ip tcp initial-time

Define the wait duration in seconds for the TCP connection to be established. This command is

supported on the , , S6000, and platforms.

ip tcp initial-time <8-75>

To restore the default behavior, which causes the wait period to be set as 8

seconds, use the no ip tcp initial-time command

CONFIGURATION

Version 9.3(0.0)

You can configure the amount of time for which the device must wait before it

attempts to establish a TCP connection. Using this capability, you can limit the wait

times for TCP connection requests. Upon responding to the initial SYN packet that

requests a connection to the router for a specific service (such as SSH or BGP) with

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

Wait duration in seconds for the TCP connection to be

established.

Introduced on the S4810, S4820T, S6000, and Z9000

IPv4 Routing