Dell S6000 Reference Manual page 751

The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Usage The following describes the show ip cam command shown in the following
Information
example.
Field
Destination
EC
CG
V
C
V Id
Mac Addr
Port
Example
Dell#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-
prefixes
Destination
----------------- -- -- - ------ --------------------
10.10.10.10
Dell#
Usage The following describes the show ip cam ecmp-group command shown in the
Information
following example.
IPv4 Routing
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for up to seven stack members.
Introduced on the S-Series.
Description
Displays the destination route of the index.
Displays the number of equal cost multipaths (ECMP)
available for the default route for non-Jumbo line cards. For
Jumbo line cards, displays 0,1 when ECMP is more than
eight.
Displays 0.
Displays a 1 if the entry is valid and a 0 otherwise.
Displays the CPU bit. 1 indicates that a packet hitting this
entry is forwarded to the CP or RP2, depending on Egress
port.
Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
Displays the next-hop router's MAC address.
Displays the egress interface. Use the second half of the
entry to determine the interface. For example, in the entry
17cl CP, the CP is the pertinent portion.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10–Gigabit Ethernet interface
EC CG V C VId Mac-Addr
0 0 1 1 0 00:00:00:00:00:00
Port
3f01 CP
751