Dell S6000 Reference Manual page 1434

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

interface-type

interface-type

INTERFACE TUNNEL

Version 9.3(0.1)

Version 9.4(0.0)

The ip unnumbered command fails in two conditions:

To ping the unnumbered tunnels, the logical address route information must be

present at both the ends.

The ipv6 unnumbered command will fail if the tunnel interface already has an

explicit IPv6 address assigned. Likewise the ipv6 address command will fail if ipv6

unnumbered is already configured. While unlikely, an interface can be configured

to be ipv6 unnumbered for IPv6 while also having an explicit IPv4 address.

Enter the interface type, followed by the type, slot and port

information.

(OPTIONAL) Instead of entering the keyword interface

followed by the interface type, slot and port information, as

above, you can enter the interface type, followed by just a

slot number.

Introduced on the S6000 and Z9000.

Introduced on the S4810, S4820T, S6000 and Z9000.

If the logical ip address is configured.

If Tunnel mode is ipv6ip (where ip address over tunnel interface is not possible).

NOTE: The ipv6 unnumbered command can specify an interface name that

does not exist or does not have a configured IPv6 address. The tunnel

interface is not changed to operationally up until the logical ip address is

identified from the one of the address family.

NOTE: The ipv6 unnumbered command can specify an interface name that

does not exist or does not have a configured IPv6 address. The tunnel

interface is not changed to operationally up until the logical ip address is

identified from the one of the address family.

Object Missing