Advertise - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

Version 8.3.11.1

Version 7.5.1.0

To perform protocol-support consistency checks on hello packets, use this

command. The adjacency-check is enabled by default.

advertise

Leak routes between levels (distribute IP prefixes between Level 1 and Level 2 and vice versa).

advertise {level1-into-level2 | level2-into-level1} prefix-

To return to the default, use the no advertise {level1-into-level2 |

level2-into-level1}[prefix-list-name] command.

level1-into-

level2-into-

prefix-list-

level1-into-level2 (Level 1 to Level 2 leaking enabled.)

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Intermediate System to Intermediate System (IS-IS)

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the E-Series.

Enter the keywords level1-into-level2 to advertise

Level 1 routes into Level 2 LSPs. This setting is the default.

Enter the keywords level2-into-level1 to advertise

Level 2 inter-area routes into Level 1 LSPs. This behavior is

described in RFC 2966.

Enter the name of a configured IP prefix list. Routes meeting

the criteria of the IP Prefix list are leaked.

ROUTER ISIS (for IPv4)

CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)

Introduced on the S6000.

Introduced on the S4820T.