Debug Ntp - Dell S6000 Reference Manual

debug ntp

Display network time protocol (NTP) transactions and protocol messages for troubleshooting.
S6000
Syntax
debug ntp {adjust | all | authentication | events | loopfilter
| packets | select | sync}
To disable debugging of NTP transactions, use the no debug ntp {adjust |
all | authentication | events | loopfilter | packets | select |
sync} command.
Parameters
adjust
all
authentication
events
loopfilter
packets
select
sync
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
System Time and Date
Enter the keyword adjust to display information on NTP
clock adjustments.
Enter the keyword all to display information on all NTP
transactions.
Enter the keyword authentication to display information
on NTP authentication transactions.
Enter the keyword events to display information on NTP
events.
Enter the keyword loopfilter to display information on
NTP local clock frequency.
Enter the keyword packets to display information on NTP
packets.
Enter the keyword select to display information on the NTP
clock selection.
Enter the keyword sync to display information on the NTP
clock synchronization.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
1417