Monitor Session - Dell S6000 Reference Manual

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.5.1.0
pre-7.7.1.0
Related

monitor session

Commands
monitor session
Create a session for monitoring traffic with port monitoring.
S6000
Syntax
monitor session session-ID (type { rpm | erpm })
To delete a session, use the no monitor session session-ID command.
To delete all monitor sessions, use the no monitor session all command.
Parameters
session-ID
type rpm |
erpm
Defaults none
Port Monitoring
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enables a monitoring session.
Enter a session identification number. The range is from 0 to
65535.
Specifies one of the following type:
• rpm: to create remote port monitoring session.
• erpm: to create encapsulated remote port monitoring
session.
1077