Distribute-List Out - Dell S6000 Reference Manual

Parameters
prefix-list-
name
interface
Defaults Not configured.
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1

distribute-list out

To restrict certain routes destined for the local routing table after the SPF calculation, apply a filter.
S6000
Syntax
distribute-list prefix-list-name out [bgp | connected | isis |
rip | static]
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter the name of a configured prefix list.
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For Port Channel groups, enter the keywords port-
channel then a number. For the C-Series and S-Series,
the range is from 1 to 128.
• For a SONET interface, enter the keyword sonet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for the Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
979