Cam-Acl - Dell S6000 Reference Manual

cam-acl

Allocate space for IPv6 ACLs.
S6000
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos
1-10 l2qos 1-10}
Parameters
default
l2acl 1-10
ipv4acl 1-10
ipv6acl 0-10
ipv4qos 1-10
l2qos 1-10
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.4.2.0
Version 8.2.1.0
Version 7.8.1.0
Usage
For the new settings to take effect, save the new CAM settings to the startup-
Information
config (write-mem or copy run start), then reload the system.
The total amount of space allowed is 16 FP blocks. System flow requires three
blocks and these blocks cannot be reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
786
Use the default CAM profile settings, and set the CAM as
follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
Allocate space to support IPv6 ACLs. Enter all of the profiles
and a range. Enter the CAM profile name then the amount to
be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series TeraScale.
Introduced on the S-Series.
Introduced on the C-Series.
IPv6 Access Control Lists (IPv6 ACLs)