Shutdown - Dell S6000 Reference Manual

Version 7.5.1.0
Version 6.1.1.0
Example
Dell(conf-if-range-so-2/0-1,fa-0/0)#show range
interface sonet 2/0 - 1
interface fastethernet 0/0
Dell(conf-if-range-so-2/0-1,fa-0/0)#
Related
interface
Commands
show ip interface
show interfaces
interface.

shutdown

Disable an interface.
S6000
Syntax
shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
684
Introduced on the C-Series.
Introduced.
— configures a physical interface on the switch.
— displays Layer 3 information about the interfaces.
— displays information on a specific physical interface or virtual
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Interfaces