Enhanced Validation Of Interface Ranges - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

Enhanced Validation of Interface Ranges

This functionality is supported on the S6000 platform.

You can avoid specifying spaces between the range of interfaces, separated by commas, that you

configure by using the interface range command. For example, if you enter a list of interface ranges,

such as interface range fo 2/0-1,te 10/0,gi 3/0,fa 0/0, this configuration is considered

valid. The comma-separated list is not required to be separated by spaces in between the ranges. You

can associate multicast MAC or hardware addresses to an interface range and VLANs by using the mac-

address-table static multicast-mac-address vlan vlan-id output-range interface

ip http source-interface

Specify an interface as the source interface for HTTP connections.

This feature is supported on S6000 platform.

ip http source-interface interface

To delete an interface, use theno ip http source-interface interface command.

The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

CONFIGURATION

Enter the following keywords and slot/port or number

information:

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For Loopback interfaces, enter the keyword loopback

followed by a number from zero (0) to 16383.

For a Port Channel interface, enter the keyword port-

channel followed by a number:

– S-Series: 1-128

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a VLAN interface, enter the keyword vlan followed by

a number from 1 to 4094.