Protocol Gvrp - Dell S6000 Reference Manual

Defaults normal
Command CONFIGURATION-INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Usage
Fixed registration prevents an interface, configured using the command line, to
Information
belong to a VLAN (static configuration) from being unconfigured when it receives a
Leave message. Therefore, Registration mode on that interface is fixed.
Normal registration is the default registration. The port's membership in the VLAN
depends on GVRP. The interface becomes a member of a VLAN after learning
about the VLAN through GVRP. If the VLAN is removed from the port that sends
GVRP advertisements to this device, the port stops being a member of the VLAN.
To advertise or learn about VLANs through GVRP, use the forbidden command
when you do not want the interface.
Related show gvrp
Commands

protocol gvrp

Access GVRP protocol — (config-gvrp)#.
S6000
Syntax
protocol gvrp
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
GARP VLAN Registration (GVRP)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
— displays the GVRP configuration including the registration.
597