Dell S6000 Reference Manual page 757

Version 8.3.7.0
Version 8.1.1.2
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip interface command shown in the
Information following example.
Lines
TenGigabitEthern
et 0/0...
Internet address...
IP MTU is...
Inbound access...
Proxy ARP...
Split horizon...
Poison Reverse...
ICMP redirects...
ICMP
unreachables...
Example
Dell#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
Dell#
Usage The following describes the show ip interface brief command shown in the
Information following example.
IPv4 Routing
Introduced on the S4810.
Supported on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the interface's type, slot/port, and physical and line
protocol status.
States whether an IP address is assigned to the interface. If
an IP address is assigned, that address is displayed.
Displays IP MTU value.
Displays the name of the configured incoming access list. If
none is configured, the phrase "not set" is displayed.
States whether proxy ARP is enabled on the interface.
States whether split horizon for RIP is enabled on the
interface.
States whether poison for RIP is enabled on the interface.
States if ICMP redirects are sent.
States if ICMP unreachable messages are sent.
757