Passive-Interface - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

This command is intended for low-speed interfaces.

passive-interface

Suppress routing updates on a specified interface.

passive-interface interface

To delete a passive interface, use the no passive-interface interface

Not configured.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.0.2.0

Version 8.3.11.1

Version 8.5.1.0

Version 8.3.7.0

Version 7.8.1.0

Enter the following information:

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/ port

information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Routing Information Protocol (RIP)