Usage
A value of 0 copies the inner packet hop limit (ipv6) or time-to-live (ipv4) in the
Information
encapsulated packet to the tunnel header hop limit (ipv6) or time-to-live (ipv4)
value.
tunnel destination
Set a destination endpoint for the tunnel.
S6000
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address
ipv6–address
Defaults
none
Command
INTERFACE TUNNEL (conf-if-tu)
Modes
Command
Version 9.3(0.0)
History
Usage
The tunnel interface is inoperable without a valid tunnel destination address for the
Information
configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the
destination address of the outer tunnel header. If you configure a tunnel interface
or source address, the tunnel destination must be compatible.
ip unnumbered
Configure a tunnel interface to operate without a unique IPv4 address and select the interface from
which the tunnel borrows its address.
This feature is supported on S6000 platform.
Syntax
ip unnumbered {interface-type interface-number}
1432
Enter the destination IPv4 address for the tunnel.
Enter the destination IPv6 address for the tunnel.
Introduced on the S4810, S4820T, S6000 and Z9000.
Object Missing