Tacacs-Server Vrf - Dell S6000 Reference Manual

Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1
Usage The key configured with this command must match the key configured on the
Information TACACS+ daemon.

tacacs-server vrf

Create an association between a TACACS server group and a VRF and source interface..
Syntax
tacacs-server vrf vrf-name [source-interface interface]
To delete the association between a TACACS server group and a VRF and source
interface, use the no tacacs-server vrf vrf-name [source-interface
interface] command.
Parameters
vrf vrf-name
interface
Security
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Authentication key length increased to 42 characters.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the keyword vrf and then the name of the VRF to
associate a TACACS server group with that VRF.
Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16838.
1265