Sflow Polling-Interval (Global) - Dell S6000 Reference Manual

Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Usage Dell Networking OS enhances the sflow implementation for real time traffic
Information analysis on the E-Series to provide extended gateway information in cases where
the destination IP addresses are learned by different routing protocols and for
cases where the destination is reachable over ECMP.
Related
show sflow
Commands

sflow polling-interval (Global)

Set the sFlow polling interval at a global level.
S6000
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval
command.
Parameters
interval value
Defaults 20 seconds
sFlow
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the sFlow configuration.
Enter the interval value in seconds. The range is from 15 to
86400 seconds. The default is 20 seconds.
1325