Dell S6000 Reference Manual page 1234

... method4
Defaults Not configured (that is, no authentication is performed).
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Version 9.2(1.0)
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.0
Usage
By default, the locally configured username password is used. If you configure aaa
Information
authentication login default, Dell Networking OS uses the methods this
command defines for login instead.
Methods configured with the aaa authentication login command are
evaluated in the order they are configured. If users encounter an error with the first
1234
• enable: use the password the enable password
command defines in CONFIGURATION mode. Not
available if role-only is in use.
• line: use the password the password command defines
in LINE mode. Not available if role-only is in use.
• local: use the password for the userid contained in the
local password database.
• none: no authentication. Not available if role-only is in
use.
• radius: use the RADIUS servers configured with the
radius-server host command.
• tacacs+: use the TACACS+ servers configured with the
tacacs-server host command.
(OPTIONAL) Enter up to four additional methods. In the
event of a "no response" from the first method, the system
applies the next configured method (up to four configured
methods).
Added support for roles on the Z9000, S6000, S4820T,
S4810, MXL
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Security