Example
Dell(conf)#router ospf 2
Dell(conf-router_ospf)#
show config
Display the non-default values in the current OSPF configuration.
S6000
Syntax
show config
Command
ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
S6000
Syntax
show ip ospf [process-id | vrf vrf name]
Parameters
process-id
vrf vrf name
Open Shortest Path First (OSPFv2 and OSPFv3)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Show only the OSPF information tied to the VRF process.
1007