Ip Msdp Cache-Rejected-Sa - Dell S6000 Reference Manual

ip msdp cache-rejected-sa

Enable an MSDP cache for the rejected source-active entries.
S6000
Syntax
ip msdp cache-rejected-sa {number}
To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command then the ip msdp cache-rejected-sa
{number} command.
Parameters
number
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.4.1.0
Related show ip msdp sa-cache rejected-sa
Commands
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
S6000
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer
address} list name command.
Multicast Source Discovery Protocol (MSDP)
Enter the number of rejected SA entries to cache. The range
is from 0 to 32766.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
927