Ip Igmp Static-Group - Dell S6000 Reference Manual

ip igmp static-group

Configure an IGMP static group.
S6000
Syntax
ip igmp static-group {group address [exclude [source address]]
| [include {source address}]}
To delete a static address, use the no ip igmp static-group {group
address [exclude [source address]] | [include {source
address}]} command.
Parameters
group address
exclude source
address
include source
address
Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
A group in include mode must have at least one source address defined. In
Information
exclude mode, if you do not specify a source address, Dell Networking OS
Internet Group Management Protocol (IGMP)
Enter the group address in dotted decimal format (A.B.C.D).
(OPTIONAL) Enter the keyword exclude then the source
address, in dotted decimal format (A.B.C.D), for which a
static entry is added.
(OPTIONAL) Enter the keyword include then the source
address, in dotted decimal format (A.B.C.D), for which a
static entry is added.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Expanded to support the exclude and include options.
615