Ip Vlan-Flooding - Dell S6000 Reference Manual

Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.3(0.0)
History
Usage For multicast mode of NLB, to associate an IP address with a multicast MAC
Information address in the switch, use address resolution protocol (ARP) by entering the arp
ip-address multicast-mac-address command in Global configuration
mode. This setting causes the multicast MAC address to be mapped to the cluster
IP address for NLB mode of operation of the switch.
Related
clear arp-cache
Commands
show arp

ip vlan-flooding

Enable unicast data traffic flooding on VLAN member ports.
Syntax
ip vlan-flooding
To disable, use the no ip vlan-flooding command.
Command CONFIGURATION
Modes
Command
Version 9.3(0.0)
History
Default Disabled
Usage By default this command is disabled. There might be some ARP table entries which
Information are resolved through ARP packets which had Ethernet MAC SA different from MAC
922
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• The interface specified here must be one of the
interfaces configured using the {output-range |
output} interface option with the mac-address-
table static command.
Added support for association of an IP address with multicast
MAC address on the S4810, S4820T, S6000, and Z9000
platforms.
— clears dynamic ARP entries from the ARP table.
— displays the ARP table.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL
platforms
Microsoft Network Load Balancing