Fefd Mode - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 8.3.11.1

Version 8.3.7.0

fefd mode

Change the FEFD mode on an interface.

fefd mode {normal | aggressive}]

To return the FEFD mode to the default of normal, use the no fefd mode

Enter a number as the time between FEFD control packets.

The range is from 3 to 300 seconds. The default is 15

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

— enables far-end failure detection.

(OPTIONAL) Enter the keyword normal to change the link

state to "unknown" when a far-end failure the software

detects on that interface. When the interface is placed in

"unknown" state, the software brings down the line protocol.

(OPTIONAL) Enter the keyword aggressive to change the

link state to "error-disabled" when a far-end failure the

software detects on that interface. When an interface is

placed in "error-disabled" state, enter the fefd reset

command to reset the interface state.