Ip Proxy-Arp - Dell S6000 Reference Manual

ip proxy-arp

Enable proxy ARP on an interface.
S6000
Syntax
ip proxy-arp
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related show ip interface
Commands
ip route
Assign a static route to the switch.
S6000
Syntax
ip route [vrf vrf-name] ip-address mask {ip-address | interface
[ip-address]} [distance] [permanent] [tag tag-value] [vrf vrf-
name]
To delete a specific static route, use the no ip route destination mask
command.
IPv4 Routing
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the interface routing status and configuration.
733