Network - Dell S6000 Reference Manual

To ensure that only specific interfaces are receiving and sending data, use the
passive-interface command with the neighbor command.
Related passive-interface
Commands

network

Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
S6000
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address
Defaults No RIP network is configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Usage
You can enable an unlimited number of RIP networks.
Information
RIP operates over interfaces configured with any address the network command
specifies.
Routing Information Protocol (RIP)
— sets the interface to only listen to RIP broadcasts.
Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1175