Interface Management - Dell S6000 Reference Manual

interfaces are assigned to different VRFs. If two interfaces are assigned to the same
VRF, you cannot configure overlapping IP subnets or the same IP address on them.
Example
Dell#int gi 1/10
Dell#show config
! interface GigabitEthernet 1/10 no ip address shutdown
Dell#
Dell#ip vrf ?
Dell#ip vrf forwarding East
Dell#show config
! interface GigabitEthernet 1/10 ip vrf forwarding East no ip
address shutdown
Dell#

interface management

Associates a management port with a management VRF.
Syntax
interface management
To delete the association between a management port and a management VRF,
use the no interface management command.
Defaults None.
Command VRF MODE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage
Use this command to associate a management port with a management VRF.
Information
When you execute this command, the management ports corresponding to both
the ACTIVE unit as well as the STANDBY unit are associated with the management
VRF.
1450
Introduced on the S-Series and Z-Series.
Virtual Routing and Forwarding (VRF)