Show Protocol-Tunnel - Dell S6000 Reference Manual

Related

show protocol-tunnel

Commands
show running-config
show protocol-tunnel
Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
S6000
Syntax
show protocol-tunnel [vlan vlan-id]
Parameters
vlan vlan-id
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.4.1.0
Example
Dell#show protocol-tunnel
System Rate-Limit: 75 frames/second
VLAN
1000
1001
1002
1003
1004
1005
Example
Dell#show protocol-tunnel vlan 2
(Specific VLAN)
System Rate-Limit: 1000 Frames/second
Interface
1318
— displays tunneling information for all VLANs.
— displays the current configuration.
(OPTIONAL) Enter the keyword vlan then the VLAN ID to
display information for the one VLAN. The range is from 1 to
4094.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series, E-Series and E-Series ExaScale.
Introduced
Protocols Interface
STP,PVST Gi 5/7,Gi 5/6
LLDP,GVRP Gi 5/7,Gi 5/6
MMRP,MVRP Gi 5/7,Gi 5/6
LACP,DOT1X Gi 5/7,Gi 5/6
OAM,PAUSE Gi 5/7,Gi 5/6
E-LMI Gi 5/7,Gi 5/6
Vlan Protocol(s)
Service Provider Bridging