Mac Learning-Limit Reset - Dell S6000 Reference Manual

mac learning-limit reset

Reset the MAC address learning-limit error-disabled state.
S6000
Syntax
mac learning-limit reset
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.7.1.0
Version 7.5.1.0
show mac-address-table
Display the MAC address table.
S6000
Syntax
show mac-address-table [address mac-address | interface
interface | vlan vlan-id] [aging-time] [dynamic | static]
[count [vlan vlan-id] [interface interface-type [slot [/
port]]]]
Parameters
address mac-
address
dynamic
Layer 2
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the keyword address then a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
(OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses the switch dynamically learns.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
871