Maximum Dynamic-Routes - Dell S6000 Reference Manual

maximum dynamic-routes

Specify the maximum number of dynamic (protocol) routes a VRF can have.
S6000
Syntax
maximum dynamic-routes limit {warn-threshold threshold-value |
warning-only}
To remove the limit on the maximum number of routes used, use the no maximum
dynamic-routes command.
Parameters
limit
warning-
threshold
warning-only
Defaults No limit is set on the maximum number of dynamic routes for a VRF.
Command CONFIGURATION-VRF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OSCommand Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0)
Usage
If the maximum route limit is not specified for a VRF, then it has unlimited space
Information
that extends to the maximum number of entries allowed for the system. This
command is not applicable to the default and management VRFs.
Virtual Routing and Forwarding (VRF)
Maximum number of routes allowed in a VRF. Valid range is
from 1 to 16,000 (or maximum allowable for that platform if
smaller value).
Warning threshold value is expressed as a percentage of the
limit value. When the number of routes reaches the specified
percentage of the limit, a warning message is generated.
Valid range is 1 to 100. When warn-threshold is used, once
the limit is reached, additional dynamic routes will not be
allowed.
When the warning-only option is used, a syslog message will
be thrown when maximum number of dynamic routes
reaches the limit. Additional dynamic routes will still allowed.
Introduced on the S–Series.
1451