show dot1x interface
Display the 802.1X information on an interface.
S6000
Syntax
show dot1x interface interface
Parameters
interface
Defaults
none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.5.1.0
Version 8.3.7.0
Version 7.6.1.0
Example
Dell#show dot1x int
802.1x information on
-----------------------------
Dot1x Status:
Port Control:
Port Auth Status:
Re-Authentication:
Untagged VLAN id:
Guest VLAN:
Guest VLAN id:
Auth-Fail VLAN:
1278
Enter one of the following keywords and slot/port or number
information:
•
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
•
For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/ port information.
•
For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
EXEC
EXEC privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the C-Series, S-Series, and E-Series.
Gi 2/32
Gi 2/32:
Enable
AUTO
UNAUTHORIZED
Disable
None
Enable
10
Enable
Security