Arp Max-Entries - Dell S6000 Reference Manual

1.
2.
3.
Beginning with Dell Networking OS version 8.3.1.0, when a gratuitous ARP is
received, Dell Networking OS installs an ARP entry on all three CPUs.

arp max-entries

Enables you to configure the maximum number of ARP entries per VRF that are allowed for IPv4..
Syntax
arp max-entries [vrf vrf-name] max-number
Parameters
vrf vrf-name
max-number
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Usage Use this command to specify the maximum number of ARP entries that the Route
Information Table Manager can hold for a specific VRF. This command does not apply to the
management VRFs.
706
At time t=0, Dell Networking OS sends an ARP request for IP A.B.C.D.
At time t=1, Dell Networking OS receives an ARP request for IP A.B.C.D.
At time t=2, Dell Networking OS installs an ARP entry for A.B.C.D only on RP2.
Enter the name of a specific VRF for which you want to
configure maximum number of ARP entries that IPv4 allows.
Enter the maximum number of ARP entries that a VRF RTM
can hold. The range is from 0 to 65535.
Introduced on the S4810 and S4820T.
IPv4 Routing