To delete access to a level and command, use the no privilege mode level
level command command.
Parameters
mode
level level
reset
command
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
1230
Enter one of the following keywords as the mode for which
you are controlling access:
•
configure for CONFIGURATION mode
•
exec for EXEC mode
•
interface for INTERFACE modes
•
line for LINE mode
•
route-map for ROUTE-MAP mode
•
router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS
and ROUTER BGP modes
Enter the keyword level then a number for the access level.
The range is from 0 to 15.
Level 1 is EXEC mode and Level 15 allows access to all CLI
modes and commands.
Enter the keyword reset to return the security level to the
default setting.
Enter the command's keywords to assign the command to a
certain access level. You can enter one or all of the
keywords.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Security