Show Ip Ospf Database - Dell S6000 Reference Manual

Command line for the system

Hide thumbs Also See for S6000:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 9.4.

Version 9.0.2.0

Version 8.3.11.1

Version 8.3.7.0

Version 7.8.1.0

Version 7.6.1.0

Version 7.5.1.0

To isolate problems with external routes, use this command. In OSPF, external

routes are calculated by adding the LSA cost to the cost of reaching the ASBR

router. If an external route does not have the correct cost, use this command to

determine if the path to the originating router is correct. The display output is not

sorted in any order.

You can determine if an ASBR is in a directly connected area (or not) by the flags.

For ASBRs in a directly connected area, E flags are set. In the following example,

router 1.1.1.1 is in a directly connected area since the Flag is E/-/-/. For remote

ASBRs, the E flag is clear (-/-/-/).

Dell#show ip ospf 1asbr

show ip ospf database

Display all LSA information. If you do not enable OSPF on the switch, no output is generated.

show ip ospf process-id [vrf vrf-name] database [database-

Added support for VRF.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support of Multi-Process OSPF.

Added the process-id option, in support of Multi-Process

Introduced on the S-Series.

Introduced on the C-Series and E-Series.

NOTE: ASBRs that are not in directly connected areas are also displayed.

Cost Nexthop

Interface Area

Open Shortest Path First (OSPFv2 and OSPFv3)