Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
pre-Version
6.2.1.1
Related
ip poison-reverse
Commands
maximum-paths
Set RIP to forward packets over multiple paths.
S6000
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Parameters
number
Defaults
4
Command
ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Routing Information Protocol (RIP)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— sets the prefix for RIP routing updates.
Enter the number of paths. The range is from 1 to 16. The
default is 4 paths.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
1173