Dell S6000 Reference Manual page 1353

priv des56
priv password
access access-
list-name
ipv6 access-
list-name
access-list-
name ipv6
access-list-
name
Defaults As above.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Version 9.0.2.0
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
Information
Simple Network Management Protocol (SNMP) and Syslog
(OPTIONAL) Enter the keywords priv des56 to initiate a
privacy authentication level setting using the CBC-DES
privacy authentication algorithm (des56).
(OPTIONAL) Enter a text string (up to 20 characters long)
password that enables the host to encrypt the contents of
the message it sends to the agent. Minimum: eight
characters long.
(Optional) Enter the standard IPv4 access list name (a string
up to 16 characters long).
(Optional) Enter the keyword ipv6 then the IPv6 access list
name (a string up to 16 characters long).
(Optional) Enter both an IPv4 and IPv6 access list name.
Added support for VRF.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
NOTE: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP. TCP and
ICMP rules are not valid for SNMP. In IPv6 ACLs port rules are not valid for
SNMP.
1353