Statistics Command - Dell S6000 Reference Manual

cp
rp1
rp2
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 6.5.1.0
pre-Version
6.1.1.0
Usage The following describes the show ip traffic summary shown in the following
Information
example.
Keyword
unknown
protocol...
not a gateway...
security failures...
bad options...
768
(OPTIONAL) Enter the keyword cp to view only statistics
from the Control Processor.
(OPTIONAL) Enter the keyword rp1 to view only the
statistics from Route Processor 1.
(OPTIONAL) Enter the keyword rp2 to view only the
statistics from Route Processor 2.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
F10 Monitoring MIB available for the ip traffic

statistics command.

Introduced on the E-Series.
Definition
No receiver for these packets. Counts packets whose
protocol type field is not recognized by Dell Networking OS.
Packets can not be routed; the host/network is unreachable.
Counts the number of received unicast/multicast packets
that could not be forwarded due to:
• route not found for unicast/multicast; ingress interfaces
do not belong to the destination multicast group
• destination IP address belongs to reserved prefixes; the
host/network is unreachable
Unrecognized IP option on a received packet.
IPv4 Routing