Logging Version - Dell S6000 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage To block a type of message parameter, set the logging trap level to a lower
Information number. For example, to block severity messages at level 6, set the level to 5.
Related
logging
Commands
logging on

logging version

Displays syslog messages in a RFC 3164 or RFC 5424 format.
Syntax
logging version {0|1}
Defaults
0
Command CONFIGURATION
Modes
Version 9.5(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Usage
To display syslog messages in a RFC 3164 or RFC 5424 format, use the log version
Information
command in configuration mode. By default, the system log version is set to 0.
The following describes the two supported log messages formats:
•
•
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series, S55.
Introduced on the C-Series.
— enables the logging to another device.
— enables logging.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
0 – Displays syslog messages format as described in RFC 3164, The BSD syslog
Protocol
1 – Displays SYSLOG message format as described in RFC 5424, The Syslog
Protocol
1375